User`s guide

4-67
Printer, Plotter, and Spooler Subsystem Programming
The IBM Network Printer 12, 17, and 24 support the following output bins. The output bins
can be accessed using the (–=) flag of the qprt command. The following table shows the
possible values and the corresponding output bin destination.
–= value (#)
destination output bin
IBM Network Printer 12
0 Main output tray
1 Face–up (rear) tray
IBM Network Printer 17
0 Main output tray
1 Mail Box Bin 1
2 Mail Box Bin 2
3 Mail Box Bin 3
4 Mail Box Bin 4
5 Mail Box Bin 5
6 Mail Box Bin 6
7 Mail Box Bin 7
8 Mail Box Bin 8
9 Mail Box Bin 9
10 Mail Box Bin 10
50 Offset Bin
–= value (#) destination output bin
IBM Network Printer 24
0 Auto Output Bin
1 Main Output Tray
2 Face–up (Rear Bin)
3 Upper Finisher Bin Face–down
4 Middle Finisher Bin Face–down
5 Lower Finisher Bin Face–down
6 Upper Finisher Bin Face–up
7 Middle Finisher Bin Face–up
8 Lower Finisher Bin Face–up
9 Auto Finisher Bin Face–down
Additional qprt option flags that are valid using the PS or PCL queue of the Network Printer
24 only: