User`s guide

4-62
Guide to Printers and Printing
2. Select the appropriate print queue and select Printer Setup on the Change/Show
Characteristics menu. Specify yes in the AUTOMATIC MODE SWITCHING for
PostScript attribute.
Notes:
a. The Japanese Base System Locale Package must be installed to print Japanese
characters.
b. Japanese characters cannot be printed with PostScript option.
c. To print multibyte characters, specify 16x16 or 32x32 dot font with the –F option using
the qprt command. For example:
qprt –Pkji –F’RomanKn23,Kanji23,IBM_JPN23’ file
IBM 4037 and IBM 4039 LaserPrinter
The system selects the IBM ASCII or PCL emulation data stream without manual
intervention.
The printers can print on paper other than the default 8–1/2 by 11 inch size. The paper size
can be changed using SMIT. This is described in ”Specifying Paper Size Using SMIT”, on
page 2-39 . To change paper size for a single print job, specify the –Q flag with the qprt
command.
Notes:
1. The Japanese Base System Locale Package must be installed to print Japanese
characters.
2. Japanese characters cannot be printed with PostScript option.
3. To print multibyte characters, specify 16x16 or 32x32 dot font with the –F option using
the qprt command. For example:
qprt –Pkji –F’RomanKn23,Kanji23,IBM_JPN23’ file
IBM 4072 ExecJet
If support for Greek or Turkish characters is needed and an NLS I font card is installed, the
system needs to know that the font card is installed:
1. As the root user, type smit chpq .
2. Select the appropriate print queue and select Printer Setup on the Change/Show
Characteristics menu.
– Specify which font card is installed in the left card slot.
– Specify which font card is installed in the right card slot.
Note: The value of the nn variable is the last two digits of the font card part number.
IBM 4076 InkJet Printer
The system selects the IBM ASCII or PCL emulation data stream without manual
intervention.
The InkJet printer can print on paper other than the default 8–1/2 by 11 inch size and on
envelopes other than the default #10 envelope. The paper and envelope size can be
changed using SMIT as described in ”Specifying Paper Size Using SMIT”, on page 2-39 . To
change paper or envelope size for a single print job, specify the –Q flag with the qprt
command.