User Manual

322
Chapter 8 Fault Messages (H-Series with Numerical Prefix)
ETHERNET
DETECTED
N/A Status message indicating
that the Network Interface
Card has established
connection.
No action is required.
ETHERNET
INITIALIZING
No Status message: the internal
Network Interface Card is
processing the boot
procedure. (May occur with
older versions of microcode.)
No action is required.
EXCEPTION ERROR No An EXCEPTION
INTERRUPT has occurred.
Contact your authorized service
representative.
1
FLASH: CHECK
RETURN
No Printer encountered an error
while trying to program Flash
memory.
Contact your authorized service
representative.
1
FLASH: WAS NOT
CLEARED
No Printer encountered an error
while trying to program Flash
memory.
Contact your authorized service
representative.
1
FLASH: WRITE
ERROR # 2
No Printer encountered an error
while trying to program Flash
memory.
Contact your authorized service
representative.
1
GENERATING XX%
NAND FLASH TABLE
No NAND FLASH is being read
and system tables are being
initialized.
No action is required.
H00: PCI SLOT ?
See User Manual
No The controller board is not
communicating with a PCI
card. This could indicate a
bad PCI card, poor
connection, or problem in
the PCI bus.
Contact your authorized service
representative.
1
H01: PCI J12
See User Manual
No The controller board is not
communicating with the PCI
card in PCI slot J12. This
could indicate a bad PCI
card, poor connection, or
problem in the PCI bus.
Contact your authorized service
representative.
1
Table 24. LCD Message Troubleshooting Table (H-Series)
Displayed Message
Can User
Correct?
Explanation Solution