User Manual

194
Chapter 4 EMULATION Menu
Ignore CH#1
Specifies character 1 for the character filtering option. Valid decimal values
are from 0 through 255.
Ignore CH#2
Specifies character 2 for the character filtering option. Valid decimal values
are from 0 through 255.
Data Bit 8
• Enable (factory default). The PI line is not passed directly from host to
printer; all 8 bits are used for data bits, and characters in the hex 80-FF
range can be accessed.
• Disable. When the host PI line is enabled, Data Bit 8 internally indicates
PI line status. To use the PI line, disable Data Bit 8, and enable the Host
PI configuration option (under the PI Control option, below).
NOTE: Data Bit 8 is interpreted as either Data Bit 8 or PI signal, but never
both. When enabled as Data Bit 8, Data Bit 8 has priority over the PI
signal, and all data above hex 7F is used to access character data
and not to interpret PI line data.
Conversely, when Data Bit 8 is disabled and the PI signal is used,
Data Bit 8 of the data is reserved for use as the PI function, and you
cannot access characters in the hex 80-FF range. Therefore, to
access characters in the hex 80-FF range, Data Bit 8 must be
enabled.
Font Set
The Font Set specifies which language is currently selected for use with the
VGL. Refer to “IGP/VGL Font Set Menu” on page 196 for available selections.
PI Control
Printer PI
• Disable (factory default). The ASCII emulation is configured with the PI
line disabled.
• Enable. The ASCII emulation is configured with the PI line enabled.
Host PI
• Disable (factory default). The host does not send PI signals.
• Enable. The host sends PI signals. The Data Bit 8 configuration option
must be disabled to transmit the PI line to the printer.