User Manual

LinePrinter Plus Emulation (H-Series Hangul)
143
Graphics Spd Up (H-Series)
This menu is used to increase (speed up) graphic printing speed by turning on
the Enhanced/Turbo mode.
• Normal (factory default). The printer prints at the given input graphics
resolution.
• Enhanced. The printer provides first-level speed up, which means the
speed is faster than Normal mode.
• Turbo. The printer provides second-level speed up, which means the
speed is faster than Enhanced mode.
• Match Typeface. The input 180x180 dpi graphics resolution will drop-dot
to the resolution which matches the typeface selected.
Page Format
Form Length
Forms length is the number of lines that can be printed on a page. You can set
the form length in inches, millimeters (mm), or as a function of the current lpi
(lines per inch).
NOTE: When IPDS is active, the form length only displays as a function of
lines.
Form Width
The form width can be specified in inches, millimeters, or as a function of the
current cpi (characters per inch). The forms width set should not exceed the
actual paper width.
NOTE: When IPDS is active, the form width only displays as a function of
characters.
Margins
• Left Margin. Set in columns. Column zero is defined as the far left edge
of the page, and column numbering increments from left to right.
• Right Margin. Set in columns. Column zero is defined as the far right
edge of the page, and column numbering increments from right to left.
• Bottom Margin. Defined in lines, starting from line zero at the bottom of
the page and incrementing from the bottom up.
Perforation Skip
• Disable (factory default). Allows printing on page perforation.
• 1/2 inch, 2/3 inch, 5/6 inch, 1 inch. You may set up a skip-over margin of
1/2 inch, 2/3 inch, 5/6 inch, or 1 inch. For example, a skip-over margin of
1 inch allows a 1 inch margin at the bottom of the page.