Manual

215
RS-232, 122
Clear to Send (CTS), 123
Data Carrier Detect (DCD), 123
Data Set Ready (DSR), 123
Data Terminal Ready (DTR), 123
Receive Data (RD), 122
Request to Send (RTS), 122
Transmit Status & Control Data (TD), 122
RS-232 Serial Interfaces, 122
RS-422, 123
RS-422 Serial Interfaces, 122
S
Save Config., 58, 59
Save, Auto, 46
Saving new configurations, 46
Saving parameter settings, 41
SCS COMMAND ERROR message, 166
SECURITY KEY NOT DETECTED message, 166
SECURITY VIOLATION message, 166
SELECT LPI, 57
SENDING PROGRAM TO EC PROCESSOR
message, 166
Serial Interfaces
RS-232, 122
RS-422, 122
Serial submenu, 68
Baud Rate, 71
Buffer Size in K, 72
Data Protocol, 69
Data Term Ready, 71
Framing Errors, 73
Idle Response, 72
Interface Type, 68
One Char Enquiry, 73
Parity, 71
Poll Character, 72
Poll Response, 72
Request to Send, 72
Stop Bits 1, 71
Word Length, 71
Set Lock Key, ADVANCED USER menu, 108
Set Sharing, ADVANCED USER menu, 107
SET TOF key, 22
SF ERROR message, 166
SHUTTLE STALL message, 167
Shuttle Timeout, ADVANCED USER menu, 107
Shuttle Type , DIAGNOSTICS, 112
Signal Strenth, WLAN PARAMS menu, 86
Signals
Centronics Parallel Interface, 117
Dataproducts Parallel Interface, 125
IEEE 1284 Parallel Interface, 118
Site requirements, 13
Slow Paper Slew, ADVANCED USER menu, 107
Software Build, DIAGNOSTICS, 112
Special information, 11
Specifications
interfaces, 172
label, 170
paper, 169
ribbon, 169
Speed print, 173
SPX FOUND, ERROR KEY NOT DETECTED
message, 167
SPX NOT NEEDED OPTIONS ENABLED
message, 167
SSID Name, WLAN PARAMS menu, 86
Status Port Numb, Printer MGMT, 114
Stop Bits 1, Serial submenu, 71
Subnet mask
Adapter Address menu, 77
Ethernet Address menu, 81
WLAN Address menu, 84
Supplies Department, 189
Switch Out On, Auto Switching submenu, 62
System Memory, DIAGNOSTICS, 112
T
TCP PORT BUSY message, 167
Tear Bar Dist. (Distance), PRINTER
CONTROL, 103
Terminating resistor configurations, 121
Terminating resistors
location of, 121
Test Width, DIAGNOSTICS, 112