Manual

214
Printer Protocol
Hangul LP+ Emulation, 95
Hanzi LP+ Emulation, 95
Printer Tests, DIAGNOSTICS, 111
PRINTER UNDER REMOTE CONTROL
message, 166
Printing rates, 173
Printing, Hex Dump, 132
Protect Configs., 59
Protocols, 12
PRT CONFIG key, 22
PTX Setup Option, ADVANCED USER menu, 105
Pwr Save Control, ADVANCED USER, 108
Q
QUEUE OVERRUN* message, 166
QUICK SETUP menu, 54
Adapter Address, 55
DBCS ASCII Style, 57
DBCS CPI, 56
DBCS/ASCII Mode, 57
Ethernet Address, 55
Graphics Speed-Up, 56
Host Interface, 55
Load Config., 57
Power-Up Config., 58
Reset Cmd CFG Ld, 57
Ribbon End Point, 57
Save Config., 58
SELECT LPI, 57
Typeface, 56
WLAN Address, 55
ZTP Data Time, 56
ZTP TearDistance, 56
ZTP Wait Time, 56
R
RBN Low Action, ADVANCED USER, 109
RBN Low Warn @, ADVANCED USER, 109
Ready, Dataproducts Parallel Interface
Signals, 125
Receive Data (RD), RS-232, 122
Reload paper, 24
REMOVE USED SPX message, 166
Renew Lifetime, WLAN Kerberos menu, 90
Report Status, Auto Switching submenu, 62
Request to Send
RS-232, 122
Serial submenu, 72
Requirements
power, 13
printer site, 13
Reset Cfg Names, 60
Reset Cmd CFG Ld, 57
Hangul LP+ Emulation, 99
Hanzi LP+ Emulation, 99
Reset Kerb. Pwd, WLAN Kerberos menu, 90
Reset LEAP Password, WLAN LEAP menu, 91
Reset LEAP User, WLAN LEAP menu, 91
Reset SSID Name, WLAN PARAMS menu, 86
Reset WEP Keys, WLAN PARAMS menu, 88
Reset WPA P-Phs, WLAN PARAMS menu, 89
Resistor configurations, terminating, 121
Resistors
installation, 122
removal, 122
Resistors, terminating
location of, 121
Resp. Polarity
Centronics (Parallel) submenu, 64
Dataproducts (Standard & Long Lines), 66
RESTORING BOOT CODE message, 166
Ret. Status Port, ADVANCED USER menu, 108
Ribbon Cartridge, changing, 38
Ribbon End Point, 57
Ribbon End Point, PRINTER CONTROL, 102
Ribbon Life Indicator, 23
Ribbon, specifications, 169