User guide

OpenPrint P7000 HD Postscript/PDF Firmware
87
Auto Save
• Enable (default). When a change has been made to a Config. menu, this
option automatically prompts the user to save or not save the change to a
Config #.
If you are currently in the Factory Config. menus and make a change,
pressing ENTER saves to Config 1 or the next available Config. and
becomes the Power-Up Config. If the Current Config is Config 1 and a
menu change is made, pressing ENTER will save the change to Config 1.
• Disable. The printer will not prompt you to save any changes made.
HOST INTERFACE Menu
The Host Interface Menu enables you to select and configure one of many
types of interfaces between the printer and your host computer. The currently
selected interface is indicated with an asterisk on the control panel message
display. Each interface has its own submenu with a set of interface
parameters which can be configured.
Twinax
1
Coax
1
IEEE 1284Auto
Switching*
Centronics Dataproducts
Serial Ethernet
1
(Available with
CT Option)
(Available with
CT Option)
(see page 90)
(see page 88)
(see page 92)
(see page 95)
(see page 97) (see page 104)
* = Factory Default
1
If installed.
E-Net
Adapter
1
(see page 103)
HOST
INTERFACE
(from page 64,
66, 68, 70, 72,
74, and 76)
HOST INTERFACE Menu