User guide

371
3270 Params menu, 143
5250 Params menu, 150
PUM Default, ANSI Emulation menu, 194
Pwr Save Control, ADVANCED USER, 258
PWRSUPP VOLT * message, 311
P7000 ANSI Firmware, Main Menu, 72
P7000 HD OpenPrint Postscript/PDF Firmware,
Main Menu, 76
P7000 LG Firmware, Main Menu, 70
P7000 PCL-II Firmware, Main Menu, 68
P7000 STD Firmware, Main Menu, 64
P7000 TN Firmware, Main Menu, 66
Q
QUEUE OVERRUN* message, 311
QUICK SETUP menu
Active Emulation, 79
Active IGP Emulation, 79
Adapter Address, 77
Device ID, 77
Ethernet Address, 78
Form Length, 79, 80
Form Width, 80, 81
Horiz Forms, 81
Host Interface, 77
Load Config., 83
Margins, 80
Max Line Width, 81
Page Length Rep, 81
Paper Size, 82
PGL SFCC, 79
Power-Up Config, 84
Printer Protocol, 79
P-Series SFCC, 80
Resolution, 82
Ribbon End Point, 83
Save Config, 84
Select CPI, 80
Select LPI, 80
Vert Forms, 81
WLAN Address, 78
ZTP Data Time, 78
ZTP TearDistance, 79
ZTP Wait Time, 78
Quiet Zone Fault, 248
R
RBN AT END POINT message, 311
RBN End Action, ADVANCED USER Menu, 260
RBN Low Action, ADVANCED USER Menu, 260
RBN Low Warn @, ADVANCED USER Menu, 259
Rcv. Status Port, ADVANCED USER Menu, 258
Ready, Dataproducts Parallel Interface
Signals, 269
Receive Data (RD), RS-232, 277
Received CR, ANSI Emulation menu, 193
Received DEL, ANSI Emulation menu, 193
REGIONx MISMATCH message, 312
Reload paper, 29
REMOVE USED SPX message, 312
Renew Lifetime, WLAN KERBEROS Menu, 118
Report Status, Auto Switching submenu, 89
Request to Send
RS-232, 277
Serial submenu, 101
Requirements
power, 17
printer site, 17
Reset Cfg Names, 86
Reset Cmd CFG Ld, 163
ANSI Emulation menu, 193
Reset Cmd CFG Ld, PCL-II Emulation, 233
Reset EAP Password, WLAN EAP Menu, 120
Reset EAP User, WLAN EAP Menu, 120
Reset Kerb. Pwd, WLAN KERBEROS Menu, 118
Reset LEAP Password, WLAN LEAP Menu, 119
Reset LEAP User, WLAN LEAP Menu, 119
Reset SSID Name, WLAN PARAMS Menu, 114
Reset WEP Keys, WLAN PARAMS Menu, 116
Reset WPA P-Phs, WLAN PARAMS Menu, 117
Resistor configurations, terminating, 275
Resistors
installation, 276
removal, 276
Resistors, terminating
location of, 276