User`s manual
Table Of Contents
- 1 Introduction
- 2 Setting Up The Printer
- 3 Operating The Printer
- 4 The Configuration Menus
- 5 Interfaces
- 6 Troubleshooting
- A Printer Specifications
- B Demand Printing
- C ASCII Character Set
- D Communication Notices
Chapter 3 Operational Procedures
72
Figure 50. Loading New Paper into the Printer
6. Pull the new paper above and behind the ribbon mask, but in
front of the existing paper. The ribbon mask location is shown
on the ribbon path diagram. If necessary, gently press the
existing paper back.
7. Align the top edge of the new paper with the top perforation of
the existing paper.
8. Load the new paper over the existing paper. Open and load the
tractors one at a time to prevent the paper from slipping.
NOTE: Make sure that the top edge of the new paper lines up with
the top horizontal perforation of the last page.
New Paper
Existing Paper