User`s manual
Table Of Contents
- 1 Introduction
- 2 Setting Up The Printer
- 3 Operating The Printer
- 4 The Configuration Menus
- 5 Interfaces
- 6 Troubleshooting
- A Printer Specifications
- B Demand Printing
- C ASCII Character Set
- D Communication Notices
Chapter 2 Connect The Interface And Power Cables
38
Connect The Interface And Power Cables
Before you connect the interface and power cables, make sure the
voltage source at the printer site conforms to the requirements
specified in “Power Requirements” on page 19.
Cabinet Models
Figure 20. Unpacking Printer Accessories
1. Make sure the printer power switch is set to O (Off).
2. Open the cabinet front door and cut the strap that secures a
box which contains the power cord, printer ribbon, control panel
overlay labels, and documentation.
3. Open the box and remove the power cord, overlays, and
documentation.
Strap