User`s manual

Appendix B Simple Tear
298
When the VIEW/EJECT key is pressed a second time, the paper
reverses the exact distance it slewed. For Simply Tear mode to
work properly:
• the form length must be set correctly;
• the Top-of-Form must be set to the actual top of form;
• there must be a space of at least 2.66 inches from the top of
form (which can be used for pre-printed headers) to prevent the
paper from falling out of the tractors when reversing. The paper
motion is shown in Figure 70.
Figure 70. Simple Tear Mode
Tear Position
Print Position
Header
Pre-Printed
Page 1
Page 2
Header
Pre-Printed
2.66" minimum
Header
Pre-Printed
Page 1
Page 2
Header
Pre-Printed
First Line
......
Last Line
Tear Position
Print Position
The form must have a minimum
header of 2.66 inches.
The forms print without the
header area at the top of each
page.
NOTE: It is possible to have the
printer print the header
information.