User`s manual
Table Of Contents
- 1 Introduction
- 2 Setting Up The Printer
- 3 Operating The Printer
- 4 The Configuration Menus
- 5 Interfaces
- 6 Troubleshooting
- A Printer Specifications
- B Demand Printing
- C ASCII Character Set
- D Communication Notices
29
P5000 Series Models:
10. Slide the paper supports outward as far as they will go.
11. Lift the hammer bank protective foam.
12. Remove the hammer bank protective foam between the ribbon
mask and the platen.
Figure 10. Removing the Hammer Bank Protective Foam - P5220 Model
P5220 Model:
13. Cut the tie wrap and remove it from the side plate.
14. Lift the hammer bank protective foam and remove it from
between the ribbon mask and the platen.
Hammer Bank
Protective Foam
Tie Wrap