User`s manual

Fault Messages
285
33 PLATEN OPEN
TIMEOUT
Yes Forms thickness
lever has been
open for at least
one minute.
Close forms thickness
lever.
PLAT INV PARM* No Fatal firmware
error on controller
board.
Contact your authorized
service representative.
1
PLAT INV CMD* No Fatal firmware
error on controller
board.
Contact your authorized
service representative.
1
PLAT INV STATE* No Fatal firmware
error on controller
board.
Contact your authorized
service representative.
1
POWER SAVER
MODE
N/A Status message:
printer is in low-
energy idle state,
all fans and higher
voltages are off,
only +5Vdc logic
circuits are active.
No action required.
PRINTER HOT Yes Controller board
sensors report high
temperatures on
the board.
Check printer
environment. If hot or
dusty, relocate printer.
Contact your authorized
service representative if
this occurs frequently.
1
PRINTER UNDER
REMOTE
CONTROL
Yes Indicates that
remote
management
software has
control of the
printer
Press any key on the
printer.
Table 16. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution