User`s manual

Chapter 6 Diagnosing Problems
284
32 PAPER JAM
TIMEOUT
Yes A timeout message
is sent to the host if
no paper motion
has occurred for 10
minutes after
CLEAR was
pressed to clear
the jam fault.
Clear paper jam and
reload paper.
31 PAPER OUT
TIMEOUT
Yes A timeout message
is sent to the host if
paper is not loaded
10 minutes after
CLEAR was
pressed to clear
the paper out fault.
Load paper.
PARAMETER
ERROR*
No Illegal parameter
value received in
command code.
Contact your system
administrator.
PARITY ERROR Yes Parity error
(serial interface)
Check your printer serial
interface parameter
settings; if necessary,
adjust them so that they
match the settings of the
attached host.
POWER SUPPLY
HOT
Yes Power supply
sensors report high
temperatures.
Check printer
environment. If hot or
dusty, relocate printer.
Contact your authorized
service representative if
this occurs frequently.
1
PROTECTED
INSTR*
No Fatal firmware
error on controller
board.
Contact your authorized
service representative.
1
Table 16. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution