User`s manual
Table Of Contents
- 1 Introduction
- 2 Setting Up The Printer
- 3 Operating The Printer
- 4 The Configuration Menus
- 5 Interfaces
- 6 Troubleshooting
- A Printer Specifications
- B Demand Printing
- C ASCII Character Set
- D Communication Notices
Chapter 4 HOST INTERFACE
234
Buffer Size in K
This option configures the amount of memory allocated for the
serial port buffer. You may specify between 1 and 16 Kbytes, in
1-Kbyte increments.
NOTE: If you select a baud rate that is 19200 or greater, you may
need to increase the Buffer Size in K parameter from the
default to 16 Kbytes to improve performance.
Poll Character
This option is for the Series1 protocol. Whenever the printer
receives this character, it sends a response to the host indicating
the current state of the printer (see Series1 protocol). It may be
configured from 0 through FF hexadecimal.
Poll Response
This option is for the Series1 protocol. After receiving a poll
character, the printer will wait the poll response time in milliseconds
before sending the response. It may be configured from 0 through
30.