User`s manual
Table Of Contents
- 1 Introduction
- 2 Setting Up The Printer
- 3 Operating The Printer
- 4 The Configuration Menus
- 5 Interfaces
- 6 Troubleshooting
- A Printer Specifications
- B Demand Printing
- C ASCII Character Set
- D Communication Notices
Chapter 4 HOST INTERFACE
224
Latch Data On
Specifies whether the data is read on the leading or trailing edge of
the data strobe signal.
Prime Signal
• Enable. The parallel port will perform a warm start (reboot) if
the host asserts the prime signal.
• Disable. The parallel port will not perform a warm start (reboot)
if the host asserts the prime signal.
TOF Action
• Reset. A form feed is performed before a warm start when the
prime signal is asserted from the host. This setting is used only
if the prime signal parameter is enabled.
• Do Nothing. Nothing occurs before a warm start when the
prime signal is asserted from the host.
Buffer Size in K
Configures the amount of memory allocated for the Centronics
parallel port buffer. You can specify between 1 and 16 Kbytes, in
1-Kbyte increments.