User`s manual

Chapter 4 HOST INTERFACE
222
Timeout
This is the value used by the printer to time out from the current port
and check the other selected port types for data to print. When the
printer has not received data from the host after a certain period of
time, it needs to timeout in order to service the other ports.
Report Status
• Disable. When a fault occurs on the printer, only the active port
reports the fault to the host.
• Enable. The port will report any fault even when it is not the
current active port.
Centronics (Parallel) Submenu
Centronics
(from page 218)
Data Bit 8
Prime
Signal
TOF Action
Buffer Size
in K
Enable*
Disable
Enable*
Disable
Standard*
Inverted
Standard*
Inverted
Enable*
Disable
Leading*
Trailing
Enable*
Disable
Reset*
Do Nothing
16*
(1-15)
* = Factory Default
PI Ignored Data
Polarity
Resp.
Polarity
Busy on
Strobe
Latch Data
On