User`s manual
Table Of Contents
- 1 Introduction
- 2 Setting Up The Printer
- 3 Operating The Printer
- 4 The Configuration Menus
- 5 Interfaces
- 6 Troubleshooting
- A Printer Specifications
- B Demand Printing
- C ASCII Character Set
- D Communication Notices
Chapter 4 ANSI Emulation
202
Barcode Darkmode
• Enable. The barcodes are printed at a higher resolution.
• Disable. The barcodes are printed at lower resolution but at a
higher speed.
PUM Default
This is the Unit of Measure (UOM) as it is used within the ANSI
emulation. Coordinates received in ESC sequences can be sent in
two UOMs: Decipoints, which is a unit of 1/720 inch, or in lines or
columns using the current LPI and CPI values. The UOM used is
determined by this configuration setting.
Truncate PI Slew
• Truncate at TOF. The slew is terminated when the next Top-of-
Form is reached. (This function applies to the ANSI EVFU
only.)
• Disable. PI slews will be completed independent of their
length.