User`s manual

Chapter 4 ANSI Emulation
200
Character Set
This parameter selects a character set for the ANSI emulation.
Note that when 0876 OCR-A or 0877 OCR-B is selected as the
print language, the Font Attributes Typeface parameter is changed
to OCR-A or OCR-B, respectively. Character sets are shown in
detail in the Character Sets Reference Manual.
Printer Select
• ON = DC1/OFF = DC3. Disables the printer when a DC1
control code is received, and enables the printer when a DC3
control code is received.
• Disable. Ignores the DC1 and DC3 control codes.
ESC c Sequence
• Enable. An ESC c code received from the host resets the
printer parameters to the factory defaults.
• Disable. An ESC c code received from the host is ignored.
Reset Cmd CFG Ld
When the printer receives a host data stream reset command
(ESC @ or ESC[K) in addition to resetting printer variables, the
selected configuration will be loaded.
• Disable. The active emulation parameters are loaded when the
reset command is executed.
• Power-Up Config. The power-up configuration is loaded when
the reset command is executed.
• Current Config. The currently selected configuration is loaded
when the reset command is executed.
• Factory Config. The factory installed configuration is loaded
when the reset command is executed.