User`s manual

Chapter 4 LinePrinter Plus Emulation
172
Set Substitution
When this option is activated, the character set overlay in RAM is
activated. This can also be accomplished through a host command
of SFCC RX. In either case, a flag is set indicating that the
substitution table is active. If the power-up configuration has Ld Set
at Pwrup and Set Substitution both enabled, the character set
overlay is automatically activated at power-up or during a soft reset.
See the LinePrinter Plus Programmer’s Reference Manual for more
information.
P-Series Emulation
Printer
Protocol
(from page 164)
Control Code
06
Control Code
08
Define CR
Code
Auto LF
Overstrike Define LF
Code
Select
SFCC
VFU Select Alt. Set
80-9F
Character
Set
SFCC d
Command
PSeries Dbl
High
8.0 LPI*
10.3 LPI
6.0 LPI
Elongated*
Backspace
CR = CR*
CR = CR + LF
Disable*
Enable
Enable*
Disable
LF = CR + LF*
LF = LF
1*
(0-7F hex)
EVFU*
DVFU
CVFU
Disable
Control Code*
Printable
(see page 177) Even dot plot*
Double high
Normal*
P3/4/6/9 Compat
* = Factory Default
P-Series
FF valid
at TOF
Enable*
Disable