User`s manual
Table Of Contents
- 1 Introduction
- 2 Setting Up The Printer
- 3 Operating The Printer
- 4 The Configuration Menus
- 5 Interfaces
- 6 Troubleshooting
- A Printer Specifications
- B Demand Printing
- C ASCII Character Set
- D Communication Notices
Chapter 4 ACTIVE IGP EMUL
104
ACTIVE IGP EMUL
This ACTIVE IGP EMUL function allows you to activate either the
PGL or the VGL emulation. There are two methods for selecting the
desired emulation. The first is by selecting the emulation directly
from the printer menu. The second is by sending a host command
which will switch the emulation automatically (see the appropriate
Programmer’s Reference Manual for details).
When changing from one IGP emulation to the other, the printer will
load the power-up configuration and the new emulation
parameters. Any configuration settings performed before selecting
these emulations that are not saved in NVRAM will be lost.
IMPORTANT
To configure an IGP emulation, the IGP emulation must be
selected in the ACTIVE IGP EMUL menu. The IGP emulation
that is not selected will not appear in the EMULATION menu
(see “Main Menu” on page 99).
ACTIVE IGP
EMUL
(from page 99)
IGP/PGL*
IGP/VGL
* = Factory Default