Instruction manual

90
Chapter 3 Diagnostic Printer Tests
Selecting and Running Diagnostic Printer Tests
NOTE: You must set TOF after running any diagnostic test.
Step Press LCD Result Notes
1. Make sure the printer is on. Raise the printer cover.
2. Load paper.
3. Set TOF. (Refer to the User’s Manual .)
4. OFFLINE
CONFIG. CONTROL
The printer must be off-
line to run a print test.
5. ENTER SWITCH
UNLOCKED
Unlocks ENTER key
and control panel.
OFFLINE
CONFIG. CONTROL
6. OFFLINE
DIAGNOSTICS
7. DIAGNOSTICS
Printer Tests
8. DIAGNOSTICS
Test Width
9. Test Width
Full Width*
10. Test Width
X
Cycle through choices.
X = Full Width or X =
80 columns.
11. Test Width
X*
Test width is selected.
12. DIAGNOSTICS
Test Width
13. DIAGNOSTICS
Printer Tests
14. Printer Tests
Shift Recycle*
15. Printer Tests
All E’s
Cycle through the
choices.
ON LINE
+
UNTIL
UNTIL
OR
ENTER
UNTIL
OR