Instruction manual

66
Chapter 3 Troubleshooting Procedures
Cycle power. Run the print job again. If the message appears,
download the emulation software again (page 130).
2. Cycle power. Run the print job again.
If the message appears, replace the CMX controller board. Record
the message and return it with defective CMX board.
PAP NOT SCHED* Message
1. Paper Not Scheduled. The paper feed process is not scheduling on the
CMX controller board, and the printer cannot feed paper.
Cycle power. Run the print job again. If the message appears,
download the emulation software again (page 130).
2. Cycle power. Run the print job again.
If the message appears, replace the MPU cable assembly.
3. Power on the printer. Run the print job again.
If the message appears, replace the power supply board.
4. Power on the printer. Run the print job again.
If the message appears, replace the shuttle frame assembly.
5. Power on the printer. Run the print job again.
If the message appears, replace the CMX controller board. Record
the message and return it with defective CMX board.
PAP NT AT SPEED* Message
1. Paper Not At Speed. Firmware error on the CMX controller board.
Cycle power. Run the print job again. If the message appears,
download the emulation software again (page 130).
2. Cycle power. Run the print job again.
If the message appears, replace the CMX controller board. Record
the message and return it with defective CMX board.
PAP UNEXP INT* Message
1. Paper Unexpected Interrupt. Firmware error on the CMX controller board.
Cycle power. Run the print job again. If the message appears,
download the emulation software again (page 130).
2. Cycle power. Run the print job again.
If the message appears, replace the CMX controller board. Record
the message and return it with defective CMX board.
PARAMETER ERROR Message
1. Illegal parameter value received in a command code over a coax/twinax
interface.
Press CLEAR then press ON LINE.