Instruction manual

The Procedures
65
undamaged and have good connections. Replace as necessary.
(Refer to Appendix A.)
3. Check hammer phasing.
Try using a lower phasing value; sometimes this message indicates
too high a hammer phase value.
4. Power on the printer. Run the print job again.
If the message appears, replace the shuttle frame assembly.
5. Power on the printer. Run the print job again.
If the message appears, replace the power supply board.
6. Power on the printer. Run the print job again.
If the message appears, replace the CMX controller board. Record
the message and return it with defective CMX board.
PAP ILLGL ST* Message
1. Paper Illegal State. Firmware error on the CMX controller board.
Cycle power. Run the print job again. If the message appears,
download the emulation software again (page 130).
2. Cycle power. Run the print job again.
If the message appears, replace the CMX controller board. Record
the message and return it with defective CMX board.
PAP INCMPL ENER* Message
1. Paper Incompletely Energized. Firmware error on the CMX controller
board.
Cycle power. Run the print job again. If the message appears,
download the emulation software again (page 130).
2. Cycle power. Run the print job again.
If the message appears, replace the CMX controller board. Record
the message and return it with defective CMX board.
PAP INVLD CMD* Message
1. Paper Invalid Command. Firmware error on the CMX controller board.
Cycle power. Run the print job again. If the message appears,
download the emulation software again (page 130).
2. Cycle power. Run the print job again.
If the message appears, replace the CMX controller board. Record
the message and return it with defective CMX board.
PAP INVLD PARM* Message
1. Paper Invalid Parameter. Firmware error on the CMX controller board.