Instruction manual

357
S
Safety, 17
notices, 17
notices, defined, 16
Safety Notices, 17
SCS COMMAND ERROR, 76
SECURITY CODE VIOLATION, 77, 134, 140
SECURITY PAL NOT DETECTED, 76
Security PAL, location, 173
Self Test
10/100Base-T, 188
Self-tests
diagnostic, printer, 89
operator print, 89
SENDING PROGRAM TO EC PROCESSOR, 77,
134, 140
SET TOF key
pedestal models, 20
SF ERROR, 77
Shaft
splined, replacement, 195
splined, skew adjustment, 122
support, replacement, 197
SHUTL INV CMD *, 78
SHUTL INV PARM *, 78
Shuttle
cover assembly, replacement, 160
does not move, 77
frame assembly, replacement, 198
Shuttle is noisy, 78
SHUTTLE JAM, 79
Signal mnemonics, 299
SIMM’s, location and replacement, 171
Smeared printing, 45
Soft reset, 98
Software
loading from multiple diskettes, 135
loading from one diskette, 130
SOFTWARE ERROR *, 80
Spacing, vertical, problems, 86
Splined shaft
replacement, 195
skew adjustment, 122
Spring
extension, hammer bank, replacement, 201
gas, assembly, replacement, 200
Squares, black, on control panel, 44
STACK
OVERFLOW *, 80
UNDERFLOW *, 80
STACKER
elevator moves by itself, 82
FAULT, 82
FULL, 83
JAM, 83
Stacker, power, 311
"chatters" at upper or lower limit, 80
does not stack properly, 80, 81
elevator does not move, 81
installation, 317
limit switch check, 83
motor check, 84
not operating, 70
printer does not detect, 70
removal, 312
replacing
constant force spring, 328
timing belts, 331
Start up sequence, 99
Status indicator
pedestal models, 20
Support shaft
replacement, 197
Switch
paper detector switch assembly, replacement,
202
platen interlock switch assembly, replacement,
203
power
location
pedestal models, 20
replacement, 148
T
TABLE MISMATCH / DOWNLOAD AGAIN, 85,
134, 140