Instruction manual

311
E SureStak™ Power Stacker
Contents
Introduction: page 311
Removing the Power Stacker: page 312
Installing the Power Stacker: page 317
Replacement Procedures:
Constant Force Spring: page 328
Timing Belts: page 331
Illustrated Parts Breakdown: page 335
Introduction
The SureStak Power Stacker is a factory-installed option for cabinet model
printers.
Most of the stacker assembly is inside the cabinet, so you must remove the
stacker assembly from the printer in order to service it or replace most of its
components.
The powered paper stacker is designed to work with forms from 5 to 12
inches (12.7 to 30.5 cm) long. Using longer or shorter paper can cause error
messages and unpredictable behavior of the stacker.
This appendix has two parts:
• Removal/installation instructions for the power stacker assembly and
components that require the most frequent replacement.
• An illustrated parts breakdown (IPB) showing how the entire power
stacker unit is assembled. The IPB also lists the part numbers for
replaceable parts.
NOTE: Only replaceable parts have part numbers in the IPB. If you need to
replace a part for which no part number is shown, replace the entire
power stacker assembly.