Instruction manual

194
Chapter 5 Section I: Replacement Procedures
Ribbon Hub
Removal
1. Prepare the printer for maintenance (page 106).
2. Loosen the Torx T-10 screw in the ribbon spool hub (page 230, item 20).
3. Remove the hub from the shaft of the ribbon drive motor.
Installation
1. Install the ribbon spool hub over the motor shaft (page 230, item 20).
2. Tighten the Torx T-10 hub screw so that it contacts the flat section of the
motor shaft.
3. Return the printer to normal operation (page 107).