Instruction manual

192
Chapter 5 Section I: Replacement Procedures
Ribbon Drive Motor
Removal
1. Prepare the printer for maintenance (page 106).
2. Remove the ribbon hub (page 194).
3. Remove two screws and washers securing the ribbon drive motor to the
base casting. (See page 230, items 18 and 19.)
4. Lift and rotate the ribbon drive motor until the motor cable is aligned with
the slot on the base casting.
5. Disconnect the ribbon drive motor cable connector.
6. Remove the ribbon drive motor.
Installation
1. Reverse steps 2 through 6 of the removal procedure above.
NOTE: The ribbon drive motor should be secured at the front right and rear
left corners. (See page 230, item 17.)
2. Return the printer to normal operation (page 107).