Instruction manual

10/100Base-T LEDs and Dipswitches
189
Dipswitches
On the back of the 10/100Base-T PrintNet Ethernet interface (inside the
printer) are two dipswitches labeled 1 and 2. The functions of these
dipswitches are explained in Table 10.
Table 10. 10/100Base-T Dipswitch Settings
Dipswitch
Description
12
OFF OFF Normal operation. With both dipswitches in the “OFF”
position, the PrintNet interface boots up using the
settings in flash memory rather than the default
settings.
ON OFF Factory default settings. With the dipswitches in this
configuration, the PrintNet interface boots up and all
settings stored in flash memory are erased except the
Ethernet address and key value.
OFF ON Default IP. With the dipswitches in this configuration,
the PrintNet interface boots up with factory default
settings, but the stored settings in flash memory
remain intact. Setting dipswitch 2 to “ON” does not
clear any settings stored in flash memory, it boots the
unit in a different state with the settings in flash
memory temporarily ignored.
ON ON If the PrintNet interface is connected to a network with
link integrity and then reset to MOS, a download will
be forced. If the unit is not connected to a network, it
will print a test page.