Instruction manual

Paper Path
177
Paper Path
NOTE: This procedure applies only to cabinet models.
Removal
1. Prepare the printer for maintenance (page 106).
2. Loosen the three paper path hold-down screws (page 214, item 6).
3. Slide the paper path to the left and lift it off the card cage.
Installation
1. Position the paper path offset slightly to the left on the card cage with the
keyway cutouts over the three loosened hold-down screws page 214,
Figure 33).
2. Slide the paper path to the right, engaging the three hold-down screws in
the keyway slots. Slide the paper path to the right as far as it will go.
3. Tighten the three hold-down screws (page 214, item 6).
4. Return the printer to normal operation (page 107).