Instruction manual

176
Chapter 5 Section I: Replacement Procedures
Paper Ironer
WARNING Over time, the upper edge of the paper ironer can become sharp. To
avoid cutting yourself, handle the paper ironer on the sides.
Removal
1. Prepare the printer for maintenance (page 106).
2. Remove the shuttle frame assembly (page 198).
3. Move the forms thickness lever to the open position.
4. Push the ends of the paper ironer toward the rear of the printer,
disengage the tabs, then lift it up and out (page 228, item 3).
Installation
NOTE: The black tape on the paper ironer faces toward the rear of the printer
and toward the paper detector switch assembly.
1. Position the paper ironer so the black tape is on the side that faces the
rear of the printer, towards the paper detector switch assembly. (See
page 228, item 3.)
2. Push the paper ironer down into the slots until the tabs engage.
3. Install the shuttle frame assembly (page 198).
4. Return the printer to normal operation (page 107).