Instruction manual

Chapter 5 Section I: Replacement Procedures

Cover Assembly, Shuttle

Removal

1. Prepare the printer for maintenance (page 106).

2. Loosen the shuttle cover screws (page 214, item 2).

3. Grasping the edges of the shuttle cover assembly, tilt the rear edge up

and lift the shuttle cover assembly out of the printer.

Installation

1. Place the shuttle cover assembly in the printer. Tilt the forward edge of

the cover down slightly and work the cover into position.

NOTE: Make sure the holes in the cover are over the locating pins on the

base casting.

2. Tighten the shuttle cover screws (page 214, item 2).

3. Return the printer to normal operation (page 107).