Instruction manual

156
Chapter 5 Section I: Replacement Procedures
5. Install the expansion-CT board, if necessary (page 162).
Install the PrintNet Ethernet interface assembly, if necessary (page 185).
6. Cabinet Models: Install the paper path (page 177).
Pedestal Models: Install the top cover assembly (page 161).
IMPORTANT If the original CMX board was replaced, you must download the
emulation software again. Installing flash memory from the old board
onto the new board does not transfer all operating system software.
7. Load flash memory (page 130).
8. 475 and 500 lpm models only: set shuttle speed if the original CMX board
was replaced (page 135).
9. Adjust the hammer phasing (page 128).
10. Adjust the paper out distance (page 124).
11. Using the configuration printout(s) you made as step 1 of the removal
procedure, reset and save the printer configuration(s). (Refer to the
User’s Manual.)