Instruction manual

Connector Stiffening Clips

151

Connector Stiffening Clips

Later model printers have connector stiffening clips on CMX board connectors

P106 and P107. The clips are also available in a field kit for installation on

earlier models. The clips stiffen connectors P106 and P107 and help prevent

accidental removal of wires when the connector shells are disconnected from

the CMX board.

Removal

1. Prepare the printer for maintenance (page 106).

2. Cabinet Models: Remove the paper path (page 177).

Pedestal Models: Remove the top cover assembly (page 161).

3. Unsnap the front (open side) of the clip from the connector shell, release

the back of the clip from the lip of connector shell P107, and work the

stiffening clip off the cable bundle. (See Figure 20.)

4. Repeat step 3 for the P106 connector.

5. Cabinet Models: Install the paper path (page 177).

Pedestal Models: Install the top cover assembly (page 161).

6. Return the printer to normal operation (page 107).

Installation