Instruction manual

14
Chapter 1 P5000 Printers
P5205B-12 500 lpm Cabinet 49 Hammers,
12 MIL tips
40 MHz
P5008 800 lpm Pedestal 49 Hammers 25 MHz
P5008-QA 800 lpm Pedestal w/Quick-
Access Cover
49 Hammers 25 MHz
P5208 800 lpm Cabinet 49 Hammers 25 MHz
P500 900 lpm Pedestal 49 Hammers 25 MHz
P5009-QA 900 lpm Pedestal w/Quick-
Access Cover
49 Hammers 25 MHz
P5209 900 lpm Cabinet 49 Hammers 25 MHz
P5010 1000 lpm Pedestal 60 Hammers 40 MHz
P5010-QA 1000 lpm Pedestal w/Quick-
Access Cover
60 Hammers 40 MHz
P5210 1000 lpm Cabinet 60 Hammers 40 MHz
P5212 1200 lpm Cabinet 91 Hammers 25 MHz
P5214 1400 lpm Cabinet 91 Hammers 40 MHz
P5214-SS 1400 lpm Cabinet
w/SureStak
Paper Stacker
91 Hammers 40 MHz
P5015 1500 lpm Pedestal 102 Hammers 40 MHz
P5015-QA 1500 lpm Pedestal w/Quick-
Access Cover
102 Hammers 40 MHz
P5215 1500 lpm Cabinet 102 Hammers 40 MHz
P5215-SS 1500 lpm Cabinet
w/SureStak
Paper Stacker
102 Hammers 40 MHz
P52KA 585 lpm Cabinet 91 Hammers
Kanji / Hanzi
40 MHz
1
The microprocessor of the Data Controller unit on the CMX controller board runs at 25
MHz or 40 MHz, depending on printer model. This means there are two kinds of CMX
controller board for these printers, used as indicated in Table 1. The 40 MHz controller
board, however, is compatible with all models that use the 25 MHz board and should be
used if the CMX board is replaced.
Table 1. P5000 Printers
Model Number
Print
Speed
Enclosure Hammer Bank
Data
Controller
Clock Speed
1