Instruction manual

134
Chapter 4 Loading Flash Memory from One Diskette
ERROR: WRONG
CHECKSUM
The printer received the complete program
but the checksum did not match. The data
were corrupted during download.
Download the program
again: Power off the
printer and start over at
step 13.
ERROR OCCURRED
FLUSHING QUEUES *
An interim message that displays while the
printer discards host data it cannot use
because a fault condition exists. While this
message displays, the asterisk (*) rotates.
Wait. When the asterisk
(*) stops rotating, a
different fault message
will appear: troubleshoot
the final message.
LOADING PROGRAM
FROM PORT XX%
The new program is loading into printer RAM.
XX indicates how much of the program has
loaded.
None
LOADING PROGRAM
INTO FLASH
The printer has deleted the previous program
from flash memory and is loading the new
program into flash memory.
None
PLEASE WAIT...
RESET IN PROGRESS
The printer finished loading the program into
flash memory and is automatically resetting
itself.
None
RESTORING
BOOT CODE
Normal download initialization message. None
SECURITY CODE
VIOLATION
The software running or being downloaded
does not match the security PAL code.
Install the correct PAL or
program. (PAL and
program must match.)
SENDING PROGRAM
TO EC PROCESSOR
The printer is loading the engine controller
program into the engine controller.
None
TABLE MISMATCH
DOWNLOAD AGAIN
EC software update in process. Download the program
again: Power off the
printer and start over at
step 13.
Table 5: Flash Memory Message Guide
Message Explanation Required Action