Instruction manual

127
21. Press >. The number of dots will move up to the top line of the display
with an asterisk (*) next to it.
22. Using the
< or ; key, adjust the XX DOTS value up or down by the
number of dots you counted in step 14. (If the comb pattern stopped short
of the perforation, increase the number of dots. If the comb pattern printed
beyond the perforation, decrease the number of dots.)
23. Press ENTER to select the new number of dots as the active value. (The
asterisk that appears tells you that it is now the active value.)
24. Press CLEAR to place the printer off-line.
“OFFLINE / CONFIG. CONTROL” displays.
25. Run the Paper Out Dots and the Paper Out Adjustment tests until the
comb pattern prints at an acceptable distance from the page perforation.
(Return to step 9.)
26. When the paper out triggering distance is acceptable, reload the paper,
feed it past any remaining unused holes that you tore in it, and set the top
of form.
27. Press
= + > (or the key combination set by the user). “ENTER SWITCH
LOCKED” briefly displays.
28. Close the printer cover.
29. Press the ON LINE key to place the printer on-line.