Instruction manual

122
Chapter 4 Splined Shaft Skew Adjustment (Figure 17)
Splined Shaft Skew Adjustment (Figure 17)
If lines of print are not parallel with the perforations on the paper, perform the
following adjustment.
1. Open the printer cover.
2. Loosen the screw (1) securing the adjusting link (2).
3. Adjust the link (2) by raising or lowering the horizontal adjustment knob
(3) to obtain print parallel with paper perforations. Tighten the screw (1).
4. Return the printer to normal operation (page 107).