Setup guide

Configuring the Printer3–42
Paper Format Menu Options
To view options, press:
DOWN
UP
RIGHT
LEFT
To select an option, press ENTER
To exit configuration (returning to
* = Factory Default
Off–Line Ready), press CLEAR
B
Y
"
A
Set at 6 LPI
Set at 8 LPI
Set at 10.3 LPI
*
Format
(From page 3–25)
Paper
Line
Spacing
Form
Length Set
Auto
Line Feed
In Inches
In 6 LPI
Lines
In 8 LPI
VFU
Select
VFU
Table
Perforation
Skip
Paper
Out
Slew
Relative
Print
Width
Lines
11.0 Inches
(Value range is
from 1.0 to 24.0
inches in 0.5 inch
increments.)
*
66 Lines
(Value range is
from 1 to 192
lines in 1 line
increments.)
*
88 Lines
(Value range is
from 1 to 192
lines in 1 line
increments.)
*
After Full Line
Disable
*
Clear
Save
Disable
1/2 Inch
2/3 Inch
5/6 Inch
1 Inch
*
End of Paper
Immediate
*
EVFU
DVFU
NVFU
CVFU
Disable
*
1 to 16
1 to 15
*
13.2 Inches
13.7 Inches
8.0 Inches
*
*
Note: Paper Format parameters vary, depending on
the Printer Protocol setting (P–Series, Serial Matrix,
or P–Series XQ). All parameters are listed here.
Set Platen
@ BOF
Slow Paper
Slew
Define
CR Code
CR = CR
CR = CR + LF
*
Define
LF Code
LF = CR + LF
LF = LF
*
Paperout
Adjust
81 Dot Rows (range
is 63 to 99)
in increments of 1.
*
PMD
Fault
Enable
Disable
*
Disable
Enable
*
Disable
Enable
*
Figure 3–9. Paper Format Menu