Setup guide

3–15Configuring the Printer
Step
Press Result Notes
1. Make a configuration printout. Refer to “Printing the Current Configuration” on page 3–12. You
may skip this step.
2. Determine which parameters you want to change, and what their new values should be. (In this
example, we are changing the value of the Line Spacing parameter from “Set at 6 LPI” to “Set at 8
LPI”.)
3. Press:
ON LINE
Off–Line
Ready 1
The printer must be
off-line to change the
configuration.
4. Raise the printer cover.
IMPORTANT
If you intend to save your changes, they will be saved into the current
configuration. T
o ensur e you have the correct Configuration selected and
loaded, do the following step.
5.
CONFIG
UNTIL
Load Saved
Completed X
Selects and loads X
(Configuration 1, 2, 3, or
4).
6.
+
ENTER Switch
Not Locked
Unlocking the ENTER key
allows you to make
configuration changes.
7.
Ribbon Life
8.
UNTIL
Paper Format
9.
Line Spacing
10.
Line Spacing
Set at 6 LPI *
Asterisk (*) indicates this
is the current setting.
(6 LPI is also the factory
default.)