Setup guide

3–11Configuring the Printer
Table 3–1. Factory Default Configuration Values (Continued)
Configuration
Parameter
Factory Default
Value
Configuration
Parameter
Factory Default
Value
Application Compatibility Host Interface Centronics
Control Code 06
4
8.0 LPI Fast Busy Enable
Control Code 08
3
Double High Strobe Polarity Standard
Overstrike Enable Latch Data On Leading Edge
Compress Print
1
01 SOH
Draft Print
1
02 STX
Host Interface
Dataproducts
Host Interface
Serial RS-232
Data Bit 8 Enable Data Protocol X-ON/X-OFF
PI Line Enable
7
Data Rate 9600 BAUD
Data Polarity Standard Word Length 8 Bits
Resp. Polarity Standard Stop Bit One
Strobe Polarity Standard Parity None
Latch Data On Leading Edge Bit 8 Function Font Select
Data T erm Ready On-Line and BNF
Request T o Send On-Line and BNF
Reverse Channel On-Line and BNF
Notes:
1. This parameter is displayed only if P-Series XQ printer protocol is selected.
2. This parameter is displayed only if Serial Matrix printer protocol is selected.
3. This parameter is displayed only if P-Series printer protocol is selected.
4. This parameter is displayed only if P-Series or P-Series XQ printer protocol is selected.
5. For P-Series printer protocol, the factory default parameter value is “EVFU”. For P-Series XQ
protocol, the value is “Enable”. For Serial Matrix protocol, the parameter is not displayed.
6. The paper out adjust value is not af fected by loading, saving, or clearing NVRAM. Its value may
only be explicitly changed in the menu.
7. If P-Series XQ or Serial Matrix printer protocol is selected, the factory default parameter value is
“Not Applicable”.