Setup guide

Configuring the Printer3–10
Factory Default Configuration Values
The printer is configured at the factory as shown in Table 3–1. All of the
values are permanently stored in ROM and are easily reloaded. To load the
factory default values, use the Load Parameters menu (page 3–19), or reset
the printer (page 3–23) if the Factory Default is the designated power–up.
Table 3–1. Factory Default Configuration Values
Configuration
Parameter
Factory Default
Value
Configuration
Parameter
Factory Default
Value
Ribbon Life Application Compatibility (Continued)
Job Rate Currently 150 Font Select /
Elongated
1
Font Select = 0E
Elongated = 08
Ribbon Size Currently 60 View Lines
When W orn Action To Stop Printer Display Language English
Enable/Disable Disable Action
Paper Format
Font Line Spacing Set at 6 LPI
Font DP AT 10 CPI Form Length Set At 1 1 Inches
Auto Line Feed After Full Line
Character Set Define CR Code CR = CR
Select Set IBM PC Define LF Code LF = CR + LF
Select Subset IBM PC GRAPHICS VFU Select
4
EVFU
5
Select Language ASCII Perforation Skip Disable
Paper Out End of Paper
Application Compatibility Paperout Adjust 1 13 Dot Rows
6
Printer Protocol P-Series PMD Fault Enable
Buffer Size 2048 Characters Slew Relative
1
1 to 16
Uppercase Select
1
Upper & Lower Set Platen @ BOF Disable
Printer Select
2
Disable Print Width 13.2 Inches
Paper Advance SW Print + Pap Adv Slow Paper Slew Disable
Power On State On-Line
Alarm On Fault Enable Host Interface Centronics
Shuttle Timeout 4 Seconds Data Bit 8 Enable
Unidirectional Disable PI Line Disable
7
Select SFCC
3
01 SOH Data Polarity Standard
80–9F Hex. Control Codes Resp. Polarity Standard