Setup guide

Configuring the Printer3–6
Off–Line
Ready
Character SetRibbon Life Font
Save ParametersLoad Parameters
Diagnostics
Application
Compatibility
Paper Format
Host Interface
Page 3–30
Page 3–33
Page 3–26
Page 3–42 Page 3–63Page 3–50
Page 3–67
Page 3–29
Page 3–66
To view options, press:
DOWN
UP
RIGHT
LEFT
To select an option, press ENTER
To exit configuration (returning to
* = Factory Default
Off–Line Ready), press CLEAR
B
Y
"
A
New Ribbon
Set Job Rate
Analyze Job
Set Ribbon Size
When Worn Action
Enable/Disable
See page 3–29 for
font options.
Select Set
IBM PC
Multinational
ECMA–94 Latin 1
DEC Multinat.
Centronics
Dataproducts
Serial RS–232
Load Saved Parameters 1
Load Saved Parameters 2
Load Saved Parameters 3
Load Saved Parameters 4
Load IGP Parameters
Load IBM 3287 Parameters
Load IBM 5225 Parameters
Load Factory Parameters
Press ENTER to save
Configuration Printout
Print Datastream in Hex Code
Printer Test 8 Inch Width
Printer Test Full Width
Print Statistics
Printer Protocol
Buffer Size
Uppercase Select
1,2
Printer Select
1,3
Paper Advance Sw
Power On State
Alarm On Fault
Shuttle Timeout
Unidirectional
Select SFCC
2,3
80–9F Hex
Control Code 06
2
Control Code 08
2
,3
Overstrike
Compress Print
1,2
Draft Print
1,2
Font Select Elongated
1,2
View
Display Language
Line Spacing
Form Length Set
Auto Line Feed
Define CR Code
Define LF Code
VFU Select
2
VFU Table
2
Perforation Skip
Paper Out
Paperout Adjust
PMD Fault
Slew Relative
1,2
Set Platen @BOF
Print Width
Slow Paper Slew
Notes:
1
Not available when P–Series protocol is selected.
2
Not available when Serial Matrix protocol is selected.
3
Not available when P–Series XQ protocol is selected.
Figure 3–2. Configuration Main Menu