Setup guide

2–20 Setting Up the Printer
Install the Ribbon
1. Raise the forms thickness lever as far as it will go.
Forms
Thickness
Lever
Figure 2–18. The Forms Thickness Lever
2. If the alarm is enabled, press the CLEAR key on the control panel to
silence the alarm.
3. Remove the ribbon spools from the package. With the ribbon to the
outside, place the right spool on the right hub. Press down on the spool
until the hub latch snaps in place.
Ribbon Guide
Ribbon Mask
Hub Latch
Hammer Bank Cover
Figure 2–19. Installing the Ribbon