Setup guide

2–19Setting Up the Printer
3. Lower the forms thickness lever. Set it to match the paper thickness. If
you are using single-part forms, set the forms thickness lever so that “A”
is next to the indicator. (See Figure 2–17.)
NOTE: Do not set the forms thickness lever too tightly; excessive friction
can cause paper jams, smeared ink, or wavy print.
Thin
Medium
Thick
A
B
C
Figure 2–17. The Forms Thickness Scale
4. Press CLEAR to clear the “Platen Open” fault.
5. Press SET TOF. The paper moves downward to the top-of-form print
position.
6. Continue with the next section to install the ribbon.