Setup guide

2–17Setting Up the Printer
10. Set the printer power switch to | (on). (See Figure 2–7, page 2–11.) The
printer warms up and tests itself. The message “Diagnostic Test In
Progress” displays on the control panel. (If there is a fault, the status
indicators will flash and a fault message will display.) After initialization,
the printer displays “On-Line.”
11. Press ON LINE. “Off-Line Ready” displays on the control panel.
12. Press FORM FEED several times to ensure that the paper feeds properly
beyond the tractors and into the paper guide assembly. Ensure the paper
folds in the same way in the stacking area as it does in the supply area.
13. Lower the upper paper guide. Close the cabinet front door.
14. Continue with the next procedure to set the top–of–form.
Upper Paper Guide
Figure 2–14. Checking the Paper Feed