Setup guide

2–8 Setting Up the Printer
Remove the Platen Protective Foam
1. Open the left and right tractor gates. Push the tractor locks down. Move
the tractors outward as far as they will go. (See Figure 2–4.)
2. Rotate the forms thickness lever away from you as far as it will go; this
is the fully open position.
3. Rotate the platen protective foam toward the front of the printer and
remove it from under the tractor support shaft.
Tractor Support Shaft
Forms
Thickness
Lever
Platen Protective Foam
Left Tractor Gate
Right Tractor Gate
Tractor Locks
Figure 2–4. Platen Protective Foam