Setup guide

Index–7
RS-232 serial interface, 4–10
Site requirements, 2–2
Skipping over perforation, 3–46
Slew Relative parameter, 3–48
Slewing paper, 1–6, 3–36, 3–41, 3–45
Specifications
dimensions, A–3
electrical, A–5
environmental, A–4
interface, A–6
labels, A–3
paper, A–2
printing and plotting rates, A–6
ribbon, A–2
weight, A–3
Speed, printing, A–6, B–4
See also Unidirectional parameter
Statistics, printer, 5–9
Stop Bit parameter, 3–59
Strobe Polarity parameter
Centronics, 3–53
Dataproducts, 3–56
T
Temperature requirements, 2–2, A–4
Terminating resistors, 4–9
Testing printer installation, 2–22
Tests, diagnostic, 5–6
Throughput, A–6
Top of form
setting, 2–18
slewing paper, 3–36
Troubleshooting
asterisk in text, 4–12
error messages, 5–16
exclamation point in text, 4–12
malformed characters, 5–7
paper motion/feeding problems, 5–7
printing a hex dump, 5–13
question mark in text, 4–12
U
U.S. ASCII character set, C–1
Unidirectional parameter, 3–37
Unlocking ENTER key, 3–7
Unpacking a new printer, 2–5
Uppercase Select parameter, 3–35
V
Values, loading customized, 3–21
Vertical page formatting, 3–45
VFU Table parameter, 3–46
View parameter, 3–41
W
Weight, A–3
When Worn Action parameter, 3–27, 6–12
Word Length parameter, 3–58
X
X–ON/X–OFF serial protocol, 4–11