Setup guide

Index–3
Error messages, 5–16
ETX/ACK serial protocol, 4–12
EVFU slew relative feature, 3–48
F
Factory configuration, 3–9, D–2
loading, 3–64
Fast Busy parameter, Centronics, 3–52
Fault conditions, setting audible alarm for,
3–37
Fault messages, 5–16
Features
optional, 1–7
standard, 1–5
Font Select / Elongated parameter, 3–41
Fonts, supported, 3–28
Form Length Set parameter, 3–43
G
Graphics
creating. See IGP (Intelligent Graphics
Processor)
supported modes, 1–6
H
Ham. Bank Hot message, 5–17
Ham. Coil Open message, 5–17
Ham. Coil Short message, 5–17
Ham. Drv. Short message, 5–17
Hexadecimal equivalents of text, printing,
5–13
High speed font parameter, 3–28
Host computer interface, compatible, 1–5
Host data stream commands, RibbonMinder,
6–21
Host data, enabling/ignoring, 3–35
Humidity, A–4
I
IBM 3287 configuration, D–5
loading, 3–63
IBM 5225 configuration, D–5
loading, 3–63
IBM emulations, 1–7
IGP (Intelligent Graphics Processor), 1–7
configuration, D–4
loading configuration, 3–63
Initializing the printer, 3–23
Input power, A–5
Inserting line feed after carriage return, 3–44
Installation
cables, 2–12
new ribbon (RibbonMinder), 6–6
power cord, 2–11
power requirements, 2–2
releasing chains, 2–10
ribbon, 2–20, 3–27
shipping restraints removal, 2–5
site requirements, 2–2
test, 2–22
Interface, parallel, alternate terminating
resistors, 4–9
Interface, serial, 4–10
Interfaces, 1–5, 4–2
Centronics parallel, 4–6
data input rate, A–5
Dataproducts parallel, 4–3
menu options, 3–49
specifications, A–6